GSI Outdoors PNEG-377 - Manual (Page 39)

39
Fan and Heater
OPERATING PROCEDURE
1. At heater turn toggle switch to "ON" position.
2. Press the "PROGRAM TEMPERATURE" but-
ton.
3. Use the increase or decrease button to set the
"PLENUM HIGH LIMIT SET POINT" to de-
sired setting (100°-160°*).
4. Press the "PROGRAM TEMPERATURE" but-
ton to continue to set the "CYCLE SETPOINT".
(hi-lo units only)
5. Use the increase or decrease buttons to set the
"CYCLE SET POINT" to desired setting (90°-
150°*) (hi-lo units only).
6. Press "programs temperature" button to continue
to set the desired "relative humidity" setting,
lower setting will run heater longer. (humidity
sensor units only) Use arrow keys to set.
7. Press the "PROGRAM TEMPERATURE" but
ton to continue to set the "TEMPERATURE
DIFFERENTIAL".
8. Use the increase or decrease buttons to set the
"TEMPERATURE DIFFERENTIAL" to 10°*.
9. Press "progam temperature" button to continue
to set "relative humidity differential". Use ar-
row keys to adjust to 5%. ( Hudidity sensor units
only).
10. Open all manual gas shut off valves, on and to
the heater unit.
11 Start the fan unit.
12. Make sure that the blade is spinning in the right
direction. If not place the toggle switch in the
"OFF" position and correct the problem.
13. After the fan reaches full speed the display should
read "AIRFLOW" in the upper right hand corner.
If not adjust air switch. (See page 19)
14. Press the start button on the heater control.
15. After 10 seconds the burner should ignite. If not,
turn "OFF" the toggle switch and then back "ON".
Repeat 12-15.
Programming the temperature differential.
Setting Gas Pressure
Starting The Dryer
*Temperatures are fahrenheit.
After heater power is turned on, the fan must be
turned on. Attempting to start the dryer without the
air switch indicating there is airflow will cause an air-
flow alarm to go off when the start switch is depressed.
The airflow alarm is simply the entire display going blank,
and the "NO AIRFLOW" message flashing for a few
seconds. The display must show "AIRFLOW" before
the dryer can be started.
To start the dryer, just push the "START" switch.
The first message to come up will be the "PURGE"
message--the drying process begins with a 10 sec-
ond purge.
When multiple heaters are connected together,
drying may be started from any heater control.