GSI Outdoors PNEG-377 - Manual (Page 5)

5
Fan and Heater
The GSI Group, Inc. recom-
mends contacting your local power
company, and having a representa-
tive survey your installation so the
wiring is compatible with their sys-
tem, and adequate power is sup-
plied to your unit.
Safety decals should be read
and understood by all people in
the grain handling area.
If a decal is damaged or is
missing contact:
GSI Group, Inc.
1004 E. Illinois St.
Assumption, IL 62510
217-226-4421
A free replacement will be sent to
you.
SAFETY
FAILURE TO INSTALL
THERMOSTAT INCREASES RISK OF FIRE IN BIN!
WARRANTIES ARE VOID ON HEATERS INSTALLED
WITHOUT THERMOSTATS.
CAUTION! BE VERY
CAREFUL WHEN
CHECKING OUT 220V OR
460V CONTROL CIRCUIT.
SERIOUS INJURY OR
DEATH MAY OCCUR IF
PROPER PRECAUTIONS
ARE NOT TAKEN.
BE SURE POWER IS
DISCONNECTED AND
LOCKED OUT BEFORE
INSTALLATION. FAILURE
TO DO SO MAY CAUSE
SERIOUS INJURY OR
DEATH
Fuel Warning
Important! Do not use propane tanks which have previously been used for ammonia unless
they have been purged according to procedures of the National L. P. Association.
Be sure fuel supply system complies with all local codes for L. P. gas installations.
DO NOT USE FLAME FOR LEAK TESTING.
Power Warning
Be sure power is disconnected and locked out before installation!
Failure to do so may cause serious injury or death.
Important! Heater must be interlocked with fan for safe operation.
Important! Thermostat must be installed for safe operation.