MiTAC 8050QMA - Manual (Page 61)

60
80 80 50QMA 50QMA N/B Maintenance N/B Maintenance
4. Remove the four screws to separate the hard disk drive from the bracket, remove the hard disk drive. (Figure 2-9)
Reassembly
1. Attach the bracket to hard disk drive and secure with four screws.
2. Slide the HDD module into the compartment and secure with one screw.
3. Place the HDD compartment cover and secure with two screws.
4. Replace the battery pack. (Refer to section 2.3.1 Reassembly)
Figure 2-9 Remove hard disk drive
MiTac Secret
Confidential Document