Warning, Disassembly procedures – Maytag MLE/MLG23MNA User Manual
Page 39
©2004 Maytag Appliances Company
16022904 Rev. 0
39
WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Disassembly Procedures
Door Disassembly
1. Disconnect power supply to unit.
2. Remove ten screws located across the bottom and along either side of the door panel. The top edge of the outer
panel is folded over the inner door plug.
Reversing Door Assembly
Note:
NOT ALL DOORS ARE REVERSIBLE
1. Disconnect power supply to unit.
2. Remove Door Assembly.
3. Remove the plastic hinge hole covers on the opposite side of the door opening.
4. Remove the hinges from the door itself and relocate them to the other side of the door.
5. Remount the door into the slots on the opposite side of the door opening in the front shroud and secure with one
screw into each hinge.
6. Mount the plastic hinge hole covers onto the side the hinges were previously on, to cover the slots in the front
shroud.
Front Panel
1. Disconnect power supply to unit.
2. Open the door and remove the four screws along the
inside lip of the door opening.
Note:
Two are located vertically on either side of the
door opening. These screws secure the front
panel to the front shroud assembly.
3. Remove the two lower screws (T-25H Torx) securing
the front panel to the lower side flanges of the cabinet
assembly (If present).
Remove
Two Screws
Counter Sunk
Screw
Door
Door
Screw
Screw
Door
Catch
Cover
Hinge
Hole
Cover
Hinge
Inner Door
Cover Plate
Door
Strike
Remove
Four
Screws