Maytag MLE/MLG23MNA - Manual (Page 48)

48 16022904 Rev. 0 ©2004 Maytag Appliances Company
WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Disassembly Procedures
4. Remove the two screws securing the coil holding
bracket.
Igniter
1. Disconnect power supply to unit.
2. Remove Front Panel.
3. Unplug igniter from Gas Valve.
4. Remove screw holding Igniter to Burner.
5. Remove the bracket and lift coils off.
Note: When repositioning the coils onto the valve, align
the coil positioning tabs and matching holes in the
coil holding bracket for each coil.
5 . Remove retaining clip from groove in shaft.
6. Remove fiber washer.
7. Remove Idler Pulley and bearing.
8. Remove second fiber washer.
Note: There is a fiber washer between the pulley and
the idler arm. When replacing parts, be certain
the order of replacement is correct,
Note: The position of the flange of the idler pulley is
important. The flange should be positioned on
the side opposite the idler arm.
Gas Valve Assembly
Coils
1. Disconnect power supply to unit.
2. Remove Front Panel.
3. Unplug wires harness from the Gas Valve Coils.
Hi-limit
Thermostat
Holding &
Booster Coil
Gas Valve
Radiant
Sensor
Igniter
Secondary
Coil
Idler Arm
Idler Shaft
Washer
Hex-Head
Bolt
Idler Pulley
Fiber
Washer Clip
Fiber
Washer