Minolta Magicolor 2200 - Manual (Page 115)

Solving Other Problems 107
Solving Other Problems
Symptom Cause Solution
Data was
sent to the
printer, but it
doesn’t print. An error message is
displayed in the message
window. Handle according to the message displayed.
The transfer belt installa-
tion guide is not set cor-
rectly in the installation rail. Remove the transfer belt. Place the front end of the
intermediate transfer unit installation guide (2 locations)
correctly in the installation rail. Next, lightly push in the
unit about 6 inches (152.4 mm). Release the top han-
dle. Holding the front handle, carefully push the transfer
belt in.
Printer
resets. Occasionally, software
applications interfere with
each other. Some applications send a printer prep file to the printer
at the beginning of each document. When this occurs,
other prep files cannot be sent without resetting the
printer. Monitor your activities to see if there is a correla-
tion between your use of a certain application and the
printer resetting. If so, contact the application developer.
Printing
takes too
much time. The printer is set to a slow
printing mode (for exam-
ple, for OHP, thick stock, or
some other special kind of
media). It takes more time to print with special media. When
using regular paper, make sure that the media type is
set properly in the driver.
The printer is set to power
saving mode. It takes a little time for printing to start in power saving
mode. If you do not want to use this mode, disable it.
The printer memory is
insufficient. Add optional memory.