Minolta Magicolor 2200 - Manual (Page 185)

Requirements 177
Power Requirements
Location Requirements
 On a hard, flat, level (1.0° or less slant at any point around the machine) surface capa-
ble of supporting the printer, accessories, consumables, and media. Weights are shown
below.


A surface can be tested for levelness with a standard round pencil. If the pencil rolls,
the surface is not level. Clear the area of any obstruction or items such as cables
that might prevent the printer from sitting directly on the flat, level surface.
 In an area with an ambient temperature range of 50°–95° F (10°–35° C) and relative
humidity range of 15%–85% (noncondensating).
 Away from cooling and heating sources, extreme temperature or humidity changes,
direct sunlight, excessive dust, corrosive chemicals or vapors (such as ammonia),
Power Japan 100 VAC 50–60 Hz 12 amps
North America 120 VAC 50–60 Hz 8 amps
Europe 220–240 VAC 50–60 Hz 6 amps
Latin America 120 VAC 50–60 Hz 8 amps
220–240 VAC 50–60 Hz 6 amps
Voltage Fluctuation Rate Japan 100 VAC ±10%
North America 120 VAC ±10%
Europe 220–240 VAC ±10%
Latin America 120 VAC ±10%
220–240 VAC ±10%
Frequency Variation Rate Within 50–60 ±3 Hz
Component Weight
Printer 87.1 lbs (39.5 kg)
Consumables (such as toner, OPC drum) 11 lbs (5.0 kg) (total)
Media 5.2 lbs (1.9 kg) per ream
Lower feeder unit (optional) 14.8 lbs (6.7 kg)
Duplex unit (optional) 5.3 lbs (2.4 kg)
5-bin mailbox (optional) 15.5 lbs (7.0 kg)