Minolta Magicolor 2200 - Manual (Page 177)

Repacking the Printer 169
Repacking the Printer
If you need to relocate or ship your printer after it’s been installed, follow the procedures
in this chapter to prevent damage to the printer and to keep your warranty valid.


If you’re returning just the printer for service, do not return the interface cables, power
cable, documentation, media tray(s), or accessories.
Attention
MINOLTA-QMS cannot be held responsible for damage to your printer during
shipment that results from the improper packaging of your printer. You must use the
instructions given in this section before repacking the printer in its original shipping
carton with the original packing materials. These supplies must be replaced prior to
re-shipping the printer.
If you need replacement packaging, in the United States, call MINOLTA-QMS
Spares at 1 (334) 633-4300 x2530 and request part number 2600674-901 for the
repacking kit. Refer to the Service & Support Guide or www.minolta-qms.com for
locations outside the United States. If you need to return the printer for service, be
sure to write the RMA (Return Merchandise Authorization) number you received
from your customer support representative clearly on the carton before shipping
the printer.
What's Involved?
Repacking your printer for shipment involves the following steps. Each is described in
more detail in the following sections.
1
Remove the cables.
2
Remove the fuser oil roller.
3
Remove the toner cartridges.
4
Remove the waste toner pack.
5
Remove the OPC drum.
6
Remove the transfer belt.
7
Remove the duplex unit (if attached).