Minolta Magicolor 2200 - Manual (Page 160)

Dual In-Line Memory Module 152
Installation
Attention
It’s very important to protect the printer controller board and the DIMM from
electrostatic damage. Before performing this procedure, review the antistatic caution
on page 151. Always handle circuit boards by the edges only.
1
Ensure that the printer is turned off and the power cord and all interface cables are
disconnected.
2
Remove the printer’s controller board.
Loosen five screws and, using the tab on the top
of the connector panel, pull the controller board
from the printer.
3
Position the controller board on a flat surface.
4
Insert the new DIMM straight down into the
DIMM connector until the latches snap into the
locked position.
Observe the keyed side of the DIMM to align it
with the connector. When seated, the DIMM
stands upright, firmly in place. If you cannot
snap the DIMM into place, do not force it.
Reposition it, making sure that the bottom of the
DIMM is seated completely in the connector.


If you need to remove the DIMM, using both
thumbs, pull the latches (one on each side of the
DIMM connector) outward. Lift the DIMM
straight out of the DIMM connector.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
................................................ ........................ .......... ................................................ ........................ ..........