Minolta Magicolor 2200 - Manual (Page 139)

Installing a Lower Feeder Unit (LFU) 131
Installation
Attention
If consumables are installed in the printer, be sure to keep the printer level when
moving it to prevent accidental spills.
If your printer is located in its permanent location, follow this procedure. Otherwise, skip
to step 3.
1
Pull out the two carrying bars on the right side
of the printer.
WARNING!
The printer weighs about 87.1 lb (39.5 kg) without accessories or consumables installed, and
133.7 lb (60.6 kg) with accessories and consumables installed. Always have two people to lift
and move the printer to avoid back injury. Additional assistance may be required if lifting
the printer above waist-level.
2
With one person holding the carrying bars and another holding the two grips on the
left side of the printer, lift the printer and temporarily move it to a flat, level surface.
3
Remove the lower feeder unit from the shipping carton, and place it where the
printer will be located.
4
Slide out the optional media tray from lower feeder unit.