Minolta Magicolor 2200 - Manual (Page 132)

Status, Error, and Service Messages 124
MEDIA JAM <x> A jam has occurred in the < x >
(input bin).
Locate and remove the
jam.
MEDIA JAM DUPLEX Media has jammed in the duplex
area or duplex refeed area on
the models with duplex units
installed. Locate and remove the
jam.
MEDIA JAM EXIT Media has jammed between the
print engine and the output tray.
A media jam has been detected
between the fuser and output
tray rollers located near the top
cover.
Exit jams occur in the media
eject area.
MEDIA JAM FUSER Media has jammed leaving the
fuser area.
MEDIA JAM MAIL BIN Mail bin jams occur if the media
is jammed in the 5-bin mailbox
between the printer and the
5-bin mailbox, in the mailbox
eject area, or in the mailbox
transport area.
MEDIA JAM MPT Media has jammed while being
pulled from the specified multi-
purpose tray.
PAPER JAM LOWER TRAY Tray jams occur between the
standard upper or optional tray
and the print engine. A misfeed
jam may be a sheet of media
not being picked, or it may be
that the media was picked but
not fed properly. Locate and remove the
jam.
This message... means... Do this...