Minolta Magicolor 2200 - Manual (Page 54)

Loading Media 46
Printing Envelopes from the Multipurpose Tray
1
Flex the envelope stack (including the edges) to remove any stiffness.
2
Place the envelopes on a flat surface, and flatten them by pressing down the corners.
3
Correct any bent corners, and then tap the envelopes on a flat surface to align them.
4
Place the envelope stack into the multipurpose tray with the flap-side up.
Check your application documentation to determine if the flap should be placed on
the left or on the right. Print a single envelope to check the orientation before print-
ing multiple copies.
5
Adjust the media guides to the width of the envelopes.
Make sure the guides are snug enough to keep the envelopes straight, but not so tight
that they buckle the envelopes.
6
Open the flap of each envelope immediately (before it cools) after the envelope is
delivered to the output tray.


Because the envelopes pass through heated rollers, the gummed area on the flaps
may seal. Using envelopes with emulsion-based glue avoids this problem.