MITSUBISHI ELECTRIC FX2N - Manual (Page 15)

FX2N-32DP-IF Profibus-DP Interface Unit Introduction 1
1-5
1.3.1 Connected Programming Tools
An FX-20P-E or personal computer can be used to monitor the devices of the 32DP-IF or to
set parameter data for special function blocks connected to the 32DP-IF. For operating instruc-
tions of the FX-20P-E or personal computer, refer to their respective operation manuals. For
device numbers and explanation, refer to chapter 4.
Connecting cable is same as FX
0N
/FX
2N
programmable controller.
Table 1.2: Connected Programming Tools
Monitoring Tools Description
FX-20P-E
“Device Monitor”, “Data Change” and “Forced ON/OFF” in the Online
Monitor /Test mode can be used for supported devices.
Personal Computer
(MELSEC MEDOC PLUS) “Device Edit” and “Entry Data Monitor” can be used for supported
devices.