Removing the media tray, Installing the media tray, Removing – IBM BladeCenter T Type 8720 User Manual
Page 60: Media, Tray, Installing
Removing
the
media
tray
Complete
the
following
steps
to
remove
the
media
tray
in
the
front
of
the
BladeCenter
T
unit:
1.
Open
the
two
release
levers
as
shown
in
the
illustration.
The
media
tray
moves
out
of
the
bay
approximately
0.6
cm
(0.25
inch).
2.
Make
sure
that
the
release
latches
are
in
the
open
position
(90°
from
the
closed
position).
3.
Grasp
the
media
tray
at
the
front
of
each
side
of
the
module
and
carefully
pull
the
module
all
the
way
out
of
the
bay.
Set
it
in
a
safe
place.
4.
Within
1
minute,
install
another
media
tray
into
the
BladeCenter
T
unit.
Installing
the
media
tray
Complete
the
following
steps
to
install
the
media
tray
in
the
front
of
the
BladeCenter
T
unit:
1.
Hold
the
media
tray
at
the
front
of
each
side
of
the
module
and
orient
the
media
tray
to
the
top
of
the
media-tray
bay.
Carefully
position
the
module
into
the
rails
in
the
media-tray
bay.
2.
Make
sure
that
the
release
latches
are
in
the
open
position
(90°
from
the
closed
position).
3.
Slide
the
media
tray
forward
into
the
media-tray
bay
until
it
stops.
4.
Push
the
media
tray
in
until
you
feel
it
lock
into
position.
5.
Push
both
release
latches
in
until
they
lock.
6.
Make
sure
that
the
power
LED
is
lit
on
the
system-status
panel.
7.
If
you
have
other
modules
to
install
at
the
front
of
the
unit,
do
so
now.
Otherwise,
reinstall
the
bezel
assembly
at
the
front
of
the
unit.
50
BladeCenter
T
Type
8720
and
8730:
Hardware
Maintenance
Manual
and
Troubleshooting
Guide