Removing an i/o module, Installing an i/o module, Removing – IBM BladeCenter T Type 8720 User Manual
Page 72: Module, Installing
Release
latch
(open)
Release
latch
(open)
Ethernet
switch
module
Fibre
Channel
switch
module
Filler
module
Filler
module
Removing
an
I/O
module
Use
the
following
instructions
to
remove
an
I/O
module
or
filler
module
from
the
rear
of
the
BladeCenter
T
unit.
1.
Press
the
release
lever
at
the
end
of
the
release
latch
and
pull
the
latch
to
the
open
position.
The
I/O
module
moves
slightly
out
of
the
bay.
2.
Slide
the
I/O
module
out
of
the
I/O-module
bay
and
set
it
aside.
3.
Within
1
minute,
install
another
I/O
module
or
filler
module
into
the
bay.
Installing
an
I/O
module
Complete
the
following
steps
to
install
an
I/O
module
into
the
rear
of
the
BladeCenter
T
unit.
1.
Press
the
release
lever
at
the
end
of
the
release
latch
and
pull
the
latch
to
the
open
position.
2.
Insert
the
I/O
module
into
the
selected
I/O-module
bay.
3.
Push
the
I/O
module
into
the
bay
until
it
stops.
The
release
latch
moves
slightly
toward
the
closed
position.
4.
Close
the
release
latch
until
it
locks
into
position.
62
BladeCenter
T
Type
8720
and
8730:
Hardware
Maintenance
Manual
and
Troubleshooting
Guide