Removing a blower module, Installing a blower module, Removing – IBM BladeCenter T Type 8720 User Manual
Page 65: Blower, Module, Installing
2
4
1
3
Release latch
(open)
Error LED
Power LED
Removing
a
blower
module
Use
the
following
instructions
to
remove
a
blower
at
the
rear
of
the
BladeCenter
T
unit.
1.
Press
the
release
lever
at
the
end
of
the
release
latch
and
pull
the
latch
to
the
open
position.
The
blower
module
moves
slightly
out
of
the
bay.
2.
Slide
the
module
out
of
the
blower
bay
and
set
it
aside.
3.
Within
1
minute,
install
another
blower
module
into
the
bay.
Installing
a
blower
module
Complete
the
following
steps
to
install
a
blower
module
into
the
rear
of
the
BladeCenter
T
unit.
1.
Press
the
release
lever
at
the
end
of
the
release
latch
and
pull
the
latch
to
the
open
position.
2.
Insert
the
blower
into
the
selected
blower
bay.
3.
Push
the
blower
module
into
the
bay
until
it
stops.
The
release
latch
moves
slightly
toward
the
closed
position.
4.
Close
the
release
latch
until
it
locks
into
position.
5.
Make
sure
that
the
blower
power
LED
is
lit
and
the
blower
error
LED
is
not
lit.
Chapter
4.
Setting
up
the
BladeCenter
T
hardware
55