Juniper Networks T1600 - Manual (Page 104)

• Media Access Control (MAC) accounting
NOTE: MAC accounting on this PIC is not supported when aggregated Ethernet is configured.
• Source and destination MAC address filtering
• Ethernet OAM 802.3ah (remote loopback is not supported for this PIC)
• Layer 2 filtering and accounting based on Layer 2 headers
• Multiple tag protocol identifiers (TPIDs) used for filtering and counting
• Flexible virtual LAN (VLAN) tagging
• Channels defined by two stacked VLAN tags
• Layer 2 protocols:
• Flexible Ethernet service
• Ethernet circuit cross-connect (CCC)
• Ethernet translational cross-connect (TCC)
• Ethernet virtual private LAN service (VPLS)
• VLAN CCC
• Extended VLAN TCC
• VLAN VPLS
Layer 3 protocols:
• IPV4
• IPV6
• MPLS
• Optical control features (vendor dependent)
• IEEE 802.3ad Link Aggregation
• Graceful Routing Engine switchover (GRES)
Software features
• Duplex SC/PC connector (RX and TX)
• 40-Gigabit Ethernet CFP transceiver: 40GBASE-LR4 (model number: CFP-40GBASE-LR4)
• Optical interface specifications—see 40-Gigabit Ethernet 40GBASE-R Optical Interface
Specifications
Cables and connectors
STATUS LED:
• Green—Online with no alarms or failures
• Yellow—PIC is initializing
• Red–PIC has a remote or local fault
• Off—Not enabled
RX LED:
• Green—Port is receiving data
• Off—Port might be on, but there is a local or remote fault
TX LED:
• Green—Port is transmitting data
• Off—Port might be on, but there is a local fault
LEDs
Copyright © 2013, Juniper Networks, Inc. 104
T1600 Core Router Interface Module Reference