Juniper Networks T1600 - Manual (Page 34)

• Multiprotocol Label Switching (MPLS) circuit cross-connect for leveraging ATM access networks
• User-configurable virtual circuit (VC) and virtual path (VP) support
• Support for idle cell or unassigned cell transmission
• OAM Fault Management processes Alarm Indication Signal (AIS), Remote Defect Indicator
(RDI), and loop cells
• Point-to-point and point-to-multipoint mode Layer 2 counters per VC and per VP
• Local and remote loopback
• ATM Inverse ARP, which enables routers to automatically learn the IP address of the router on
the far end of an ATM PVC
• Simple Network Management Protocol (SNMP):
• Management Information Base (MIB) 2 (RFC 1213)
• ATM MIB (RFC 1695)
• SONET MIB
• Unspecified bit rate (UBR), non-real-time variable bit rate (VBR), and constant bit rate (CBR)
traffic shaping
• Per-VC or per-VP traffic shaping
• Support for F4 OAM cells
• Support for 16-bit VCI range
Software features
• You can install different transceivers on the PIC.
• Duplex LC/PC connector (RX and TX)
• SONET/SDH OC48/STM16 fiber-optic SFP transceivers:
• Multimode (model number: SFP-OC48-SR)
• Intermediate reach (IR-1) (model number: SFP-OC48-IR)
Optical interface specifications—see SONET/SDH OC48/STM16 Optical Interface Specifications
Cables and connectors
One tricolor per port:
• Off—Not enabled
• Green—Online with no alarms or failures
• Yellow—Online with alarms for remote failures
• Red—Active with a local alarm; router has detected a failure
LEDs
Copyright © 2013, Juniper Networks, Inc. 34
T1600 Core Router Interface Module Reference