Juniper Networks T1600 - Manual (Page 76)

• You can install any transceiver supported by the PIC.
• Fiber-optic small form-factor pluggable (SFP) transceivers:
• Duplex LC/PC connector (Rx and Tx)
• 1000BASE-LH (model number: SFP-1GE-LH)
• 1000BASE-LX (model number: SFP-1GE-LX)
• 1000BASE-SX (model number: SFP-1GE-SX)
• Optical interface specifications—see Gigabit Ethernet 1000BASE Optical Interface
Specifications
• 1000BASE-BX (model number pairs: SFP-GE10KT13R14 with SFP-GE10KT14R13,
SFP-GE10KT13R15 with SFP-GE10KT15R13, SFP-GE40KT13R15 with SFP-GE40KT15R13)—See
Fast Ethernet and Gigabit Ethernet Bidirectional SFP Optical Interface Specifications
• Copper transceiver:
• Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
• 1000BASE-T (model number: SFP-1GE-T)
• Pinout: MDI crossover
• Copper interface specifications—see Gigabit Ethernet 1000BASE-T Copper Interface
Specifications
NOTE: Do not install SONET/SDH OC48c/STM16 SFPs in a Gigabit Ethernet port. The port will
not recognize the SFP.
Cables and connectors
Status LED, one tricolor:
• Off—Not enabled.
• Green—Online with no alarms or failures.
• Yellow—Online with alarms for remote failures.
• Red—Active with a local alarm; router has detected a failure.
NOTE: The green Status LED is lit on the 2-port Gigabit Ethernet IQ PIC when at least one port
is online.
Port LEDs, one per port:
• Off—Port is down.
• Green—Link is established.
LEDs
Related
Documentation
T1600 PIC Description on page 3 •
• High Availability Features on page 4
• T1600 PIC Combination Limitations on page 18
• T1600 PICs Supported on page 5
Copyright © 2013, Juniper Networks, Inc. 76
T1600 Core Router Interface Module Reference