Juniper Networks T1600 - Manual (Page 140)

• Configuration of SONET or SDH framing on a per-port basis on the 4-port Type 4 PIC
• SONET/SDH framing
• Link aggregation
• Alarm and event counting and detection
• Dual-router automatic protection switching (APS)
• Multiprotocol Label Switching (MPLS) fast reroute
• Encapsulations:
• Circuit cross-connect (CCC)
• Translational cross-connect (TCC)
• Frame Relay
• High-Level Data Link Control (HDLC)
• Point-to-Point Protocol (PPP)
Software features
• Duplex LC connector (Rx and Tx)
• SONET/SDH OC192c/STM64 XFP transceivers:
• Short reach (SR-1) (model number: XFP-10G-L-OC192-SR1)
• Intermediate reach (IR-1) (model number: XFP-10G-E-OC192-IR2)
• Long reach (LR-1) (model number: XFP-10G-Z-OC192-LR2)
Optical interface specifications—see SONET/SDH OC192/STM64 Optical Interface Specifications
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid links,
take the PIC offline until you are ready to establish a link to another device. For information about
taking a PIC offline, see the
request chassis pic offline command in the Junos OS Operational Mode
Commands.
Cables and connectors
One tricolor LED per port:
• Off—Not enabled
• Green—Online with no alarms or failures
• Yellow—Online with alarms for remote failures
• Red—Active with a local alarm; router has detected a failure
One 768 over 192 LED:
• Off—Not enabled
• Green—Online with no alarms or failures
• Yellow—Online with alarms for remote failures
• Red—Active with a local alarm; router has detected a failure
LEDs
Copyright © 2013, Juniper Networks, Inc. 140
T1600 Core Router Interface Module Reference