Juniper Networks T1600 - Manual (Page 26)

• Per-virtual circuit (VC) and per-virtual path (VP) traffic shaping
• Unspecified bit rate (UBR) traffic shaping
• Fine-grained variable bit rate (VBR) traffic shaping
• Circuit cross-connect (CCC)
• ATM Inverse Address Resolution Protocol (ARP), which enables routers to automatically learn
the IP address of the router on the far end of an ATM permanent virtual circuit (PVC)
• Simple Network Management Protocol (SNMP):
• Management Information Base (MIB) 2 (RFC 1213)
• ATM MIB (RFC 1695)
• SONET MIB
• AAL5 encapsulations:
• ATM-VC-MUX
• ATM-NLPID
• ATM-Cisco-LLPID
• ATM-SNAP
• ATM-CCC-VC-MUX
Software features
• 10 ft (3.05 m) posilock SMB to BNC (provided)
• Four pairs of Rx and Tx coaxial cables
Cables and connectors
One tricolor per port:
• Off—Not enabled
• Green—Online with no alarms or failures
• Yellow—Online with alarms for remote failures
• Red—Active with a local alarm; router has detected a failure
LEDs
• Alarm indication signal (AIS)
• Frame error
• Line code violation
• Local and remote loopback
• Loss of signal (LOS)
• Out of frame (OOF)
• Yellow alarm
Alarms, errors, and
events
Related
Documentation
T1600 PIC Description on page 3 •
• High Availability Features on page 4
• T1600 PIC Combination Limitations on page 18
• T1600 PICs Supported on page 5
Copyright © 2013, Juniper Networks, Inc. 26
T1600 Core Router Interface Module Reference