Juniper Networks T1600 - Manual (Page 94)

• Two modes of operation: 5 ports in line-rate mode, 10 ports in oversubscribed mode
• Intelligent handling of oversubscribed traffic
• Flexible mapping of port-assigned queues and scheduler resources at both ingress and egress
• Strict-priority queue available on a per-port basis
• QoS available on a per-port basis
• Weighted round-robin (WRR)
• L2 Protocol support:
• Ethernet CCC, Ethernet TCC, Ethernet VPLS
• VLAN CCC
• Extended VLAN TCC
• VLAN VPLS
• Flexible-Ethernet-services
• L3 Protocol support
• IPv4
• IPv6
• MPLS
• VLAN support
• 4000 VLANs per PIC
• Flex-VLAN tagging support
• Interrupt driven link-down detection
• Pause frame support
• Jumbo frame support
• MAC learning, aging, policing, and filtering
• Virtual Router Redundancy Protocol (VRRP) support
• IEEE 802.3ad Link Aggregation (For routers in a routing matrix, Junos OS Release 11.2 and later
is required)
NOTE: For PICs that support oversubscription, the PIC must be in line-rate mode to support
aggregated Ethernet.
• DSCP rewrite is supported for Junos OS Release 11.4 and later.
Software features
• Duplex LC/PC connector (Rx and Tx)
• 10-Gigabit SFP+ transceivers:
• 10GBASE-ER (model number: SFPP-10GE-ER) Junos OS Release 12.1 and later
• 10GBASE-LR (model number: SFPP-10GE-LR)
• 10GBASE-SR (model number: SFPP-10GE-SR)
• 10GBASE-ZR (model number: SFPP-10GE-ZR) Junos OS Release 12.3 and later
• Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications
Cables and connectors
Copyright © 2013, Juniper Networks, Inc. 94
T1600 Core Router Interface Module Reference