Juniper Networks T1600 - Manual (Page 74)

• You can install any transceiver supported by the PIC.
• Fiber-optic SFP transceivers:
• Duplex LC/PC connector (Rx and Tx)
• 1000BASE-LH (model number: SFP-1GE-LH)
• 1000BASE-LX (model number: SFP-1GE-LX)
• 1000BASE-SX (model number: SFP-1GE-SX)
• Optical interface specifications—see Gigabit Ethernet 1000BASE Optical Interface
Specifications
• 1000BASE-BX (model number pairs: SFP-GE10KT13R14 with SFP-GE10KT14R13,
SFP-GE10KT13R15 with SFP-GE10KT15R13, SFP-GE40KT13R15 with SFP-GE40KT15R13)—See
Fast Ethernet and Gigabit Ethernet Bidirectional SFP Optical Interface Specifications
• Copper transceiver:
• Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
• 1000BASE-T (model number: SFP-1GE-T)
• Pinout: MDI crossover
• Copper interface specifications—see Gigabit Ethernet 1000BASE-T Copper Interface
Specifications
NOTE: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize
the SFP.
Cables and connectors
Status LED, one bicolor:
• Off—PIC is not enabled.
• Green—PIC is operating normally.
• Red—PIC has an error or failure.
Port LEDs, one pair per port:
• Link—If green, the port is online; if there is no light, the port is down.
• Activity—If flashing green, the port is receiving data; if there is no light, the port might be on but
is not receiving data.
LEDs
Related
Documentation
T1600 PIC Description on page 3 •
• High Availability Features on page 4
• T1600 PIC Combination Limitations on page 18
• T1600 PICs Supported on page 5
Copyright © 2013, Juniper Networks, Inc. 74
T1600 Core Router Interface Module Reference