Juniper Networks T1600 - Manual (Page 28)

• Circuit cross-connect (CCC) for leveraging ATM access networks
• User-configurable virtual circuit (VC) and virtual path (VP) support
• Support for idle cell or unassigned cell transmission
• OAM fault management processes alarm indication signal (AIS), remote defect indication
(RDI) cells, and loop cells
• Point-to-point and point-to-multipoint mode Layer 2 counters per VC and per VP
• Local and remote loopback
• ATM Inverse Address Resolution Protocol (ARP), which enables routers to automatically learn
the IP address of the router on the far end of an ATM permanent virtual circuit (PVC)
• Simple Network Management Protocol (SNMP):
• Management Information Base (MIB) 2 (RFC 1213)
• ATM MIB (RFC 1695)
• SONET MIB
• Unspecified bit rate (UBR), non-real-time variable bit rate (VBR), and constant bit rate (CBR)
traffic shaping
• Per-VC or per-VP traffic shaping
• Support for F4 OAM cells
• Support for 16 bit VCI range
Software features
• Duplex SC/PC connector (RX and TX)
• SONET/SDH OC3/STM1 fixed transceivers:
• Multimode
• Intermediate reach (IR-1)
Optical interface specifications—see SONET/SDH OC3/STM1 Optical Interface Specifications
Cables and connectors
One tricolor per port:
• Off—Not enabled
• Green—Online with no alarms or failures
• Yellow—Online with alarms for remote failures
• Red—Active with a local alarm; router has detected a failure
LEDs
Copyright © 2013, Juniper Networks, Inc. 28
T1600 Core Router Interface Module Reference