JVC VR-609 - Manual (Page 43)

-- 43 --
VR-609
5.1.2.2 Camera Name
Create an alphanumeric nickname of up to 16 characters (including symbols) as
shown below. Turn the Jog to see the next character repeatedly.
How to Use
1) Select Name using the up/down buttons or Jog.
2) Press the ENTER button.
3) Writes and amends using the left/right button and Jog.
4) Press the ENTER button to complete.
It is NOT possible to display all the characters when the screen is divided into more
than 6 pictures. In this case "…" will be displayed.
5.1.2.3 Pan/Tilt Camera Setup
Camera Setting : Camera ID, Reverse Pan, Reverse Tilt, Control Test
Character Mark
1) Camera ID : For controlling the Pan/Tilt camera.
Setting ID is for distinguish the Pan/Tilt camera, which is connected in parallel.
Camera ID uses 1~32 number.
(Be sure to check the specifications of the Pan/Tilt cameras.)
2) Reverse Pan, Reverse Tilt : It reverses a Pan/Tilt Camera direction.
Usually, the Pan/Tilt direction can be changed depending on the location
and mounting of the Pan/Tilt camera.
3) Control Test : Possible to test whether Pan/Tilt Camera setup is correct or not.
Useful when checking after setup finishes.
Blank ! “ # $ % & ’ ( ) ” + , - . / 0 1 2 3 4 5 6 7 8 9 : ; < = > ?
@ A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
[ ＼ ] ^ _` a b c d e f g h I j k l m n o p q r s t u v w x y z { | } ~
!
For the control No., set to the value same as the ID that has been set at the
Pan/Tilt camera. !