JVC VR-609 - Manual (Page 54)

-- 54 --
VR-609
5.2.2.9 Specific Day Schedule
・You can configure the recording schedule of a specific day by pressing the ENTER
button in the ‘Specific Days…’.
① Using the left/right arrow buttons and the ENTER button and selecting the ‘Add’, you
can add and configure new “Specific Day Schedule” up to 16.
② Move cursor to the Recording Quality field, followed by pressing the ENTER button to
set the picture quality during recording.
③ Move cursor to the Audio field and press the ENTER button to adjust the audio settings.
→See 5.2.1.2 Quality (P.47) for the configuration procedures.
④ Using the up/down arrow buttons and the ENTER button and Jog dial and selecting the
“Enable/Disable”, you can decide if you will record it according to the configuration of
recording schedule, or not.
⑤ Using the up/down arrow buttons and the ENTER button and Jog dial and selecting the
“Delete”, you can delete the configured recording schedule.
⑥ The fraction displayed on the upper left of the window means the following: a numerator
= a number of timer program which is setting now, a denominator = the total number of
the timer programs.
! ・Please do not set-up a channel without video input as record. Please remove all
checks such as Always, Alarm, and Motion.
・Actual record will be till end time +1 minute.
1) Move to the position where changes are to be made.
2) Adjust the values using the Up/Down/Left/Right buttons, followed by pressing the
ENTER button to confirm.
* The timer program can be also enabled/disabled here.
* When recording end time is set to before start time, the input error screen is
displayed. Please set-up again.
⑦ Move cursor to the position where the program is displayed (start time - end time),
followed by pressing the ENTER button to set the start time/end time of the timer
program.
①
②
④ ③
⑤
⑥
⑦