JVC VR-609 - Manual (Page 66)

-- 66 --
VR-609
■ Log Screen
Log screen contents are as follows:
Motion Detect
Menu Setup Network Access
Power On/Off Video Loss
Disk Full Alarm In 1-9
・On the system log display screen, if you chose a log line by the vertical button or JOG
Dial and then press the ENTER button, playback the recorded image starts from the
time when the log was recorded. If there was no record image when a log is recorded,
playback the recorded image from the nearest position. As pressing a stop button, it
will return to a system log screen.
・Searches/Displays the system log of each of the HDDs. Use the Left/Right buttons to
search the HDD accordingly using the relevant search criteria.
・A system log can be saved to 250,000 per HDD. When exceeded, it is overwritten and
deleted.
・A system log is usually aligned in order of time and displayed. When a system log is
overwritten exceeding 250,000, a system log could not be aligned in order of time.
・A system log goes on recording after the DISK FULL. When a system log goes on
recording exceeding 250,000, the disagreement of a recording image and a system
log could occur. For avoiding this, please execute recording with checking "Overwrite
Disk When Disk Full".
・When you specify the log line that is older than the recorded image remains in HDD
and press ENTER, it could jump on the latest image if “Overwrite Disk When Disk Full”
is checked. If it is not checking to "Auto Repeat" of a Playback menu at this time, it
will become the stop mode at the latest image. In such a case, please check to "Auto
Repeat“ then reproduces the latest pictures and the oldest pictures continuously.
The HDD number
which shows the log.