JVC VR-609 - Manual (Page 50)

-- 50 --
VR-609
・Recording Schedule is set-up in block. Minimum block is an hour.
・Recording block is displayed red. No recording block is displayed black.
・Selected block is displayed blue.
・You can set-up Recording Schedule by moving the yellow bar.
A time setting cannot be operated from the remote control unit. Please use
the front panel buttons.
■ How to Setup Recording Schedule Block
5.2.2.2 How to Setup
!
00 01 02 03 04 05
00 01 02 03 04 05
１
１
4) Use the Left/Right buttons to determine the start position.
5)
When the DISPLAY button is pressed, a yellow bar indicating the end position
(lower half) will be displayed. The area between the start and end positions will
be displayed in gray color.
6) Use the Left/Right buttons to determine the end position.
7) Press the ENTER button to display the even recording configuration screen.
→See 5.2.2.3 Recording Events (P.50) for configuration of event recording.
* Press the EXIT button during time setting to cancel the setting.
1) Move the cursor on a timer display domain on a Recording Schedule screen, and
press the ENTER button.
2) Select the channel to be set-up using the up/down button or jog.
3) When the DISPLAY button is pressed, a yellow bar indicating the start position
(upper half) will be displayed.
5.2.2.3 Recording Events
・Perform the following to open the even recording configuration screen.
(When record zone remains unchanged)
1) Align cursor with the timer display zone in the program timer configuration
screen, followed by pressing the ENTER button.
2) Use the Up/Down buttons or jog dial to select the channel.
3) Use the Left/Right buttons to move to the block to be configured, followed
by pressing the ENTER button.
(When the record zone is changed)
1) Set the record zone and press the ENTER button.
→See 5.2.2.2 How to Setup (P.50) for details on changing the record zone.