JVC VR-609 - Manual (Page 51)

-- 51 --
VR-609
5.2.2.4 Quality
・Check/Uncheck the check box to enable/disable recording.
Use the ENTER button to check/uncheck the check box.
・Always: Recording during the schedule period.
・Alarm: Record when the selected alarm is received.
・Motion: Record when motion is detected in the configured channel.
・Field rate can be altered accordingly in the Field Rate fields.
1) Move cursor to the Field Rate field and press the ENTER button.
2) Use the Left/Right buttons to determine whether to alter the field rate or number of
seconds.
3) Select a value using the Up/Down buttons or JOG, followed by pressing the ENTER
button.
・Press the "OK" button to confirm the settings upon completing.
・Press the "Cancel" or EXIT button to cancel the setting.
* The field rate is automatically adjusted by the channel number which simultaneous
recording. Please confirm on "Recording Schedule" screen before finishing setup.
* Please notice that a boundary line will disappear if an adjacent block is set to the
same setup.
The recording quality window can be opened by moving the cursor to the QL position
bar and pressing the ENTER button.
■ How to Setup
1) Move the cursor to the scroll bar and press the ENTER button to change the
picture quality settings.
2) Alter the picture quality settings accordingly using the Up/Down buttons, followed
by pressing the ENTER button to confirm the settings.
3) Press the "OK" button to confirm the settings.
*Press the "Cancel" or EXIT button to cancel the settings.
・Set-up range : Q1-Q4, HQ1-HQ3. (Default setting : Q3)
(Q1=Low, HQ3=the Highest.)
・Picture quality settings cannot be specified separately for individual cameras.
・Picture quality settings can be specified in the same way as recording time on a
per-hour basis. (Please refer to 5.2.2.2 How to Setup (P.50))
・Field Rate of Always
・Field Rate of Alarm/Motion.
(Can not specify less than 1F/1Sec.)