JVC VR-609 - Manual (Page 47)

-- 47 --
VR-609
Press the ENTER button at the selected block to set-up Recording Events of block like
the below picture.
・Selection of audio recording is possible at the field to the right of the QA line. Press
the ENTER button to switch between "Audio Off" and "Audio On".
5.2.1.1 Recording Events
5.2.1.2 Quality
・Changes ON/OFF of a check BOX by using ENTER button.
・Always : Keep on recording during Recording Time.
・Motion : Starts Recording when the motion is detected.
・Alarm : Starts Recording when the selected alarm is detected.
・Changes the value on the column of Field Rate.
1) Move the cursor on the column of Field Rate, and press the ENTER button.
2) Set-up Field number or Second using the left/right button.
3) Change the value using up/down button or JOG, and press the ENTER button to finish
setup.
* The field rate is automatically adjusted by the channel number. Please confirm on
"Manual Recording" screen before finishing setup.
!
・Field Rate of Always
・Field Rate of Alarm/Motion.
(Can not specify less than 1F/1Sec.)
・Press the ENTER button on the left-side of the "QA" line to set-up Recording Quality
like above picture.
・Picture quality settings cannot be specified separately for individual cameras.
・Setup range : Q1 - Q4, HQ1 - HQ3.
(Default setting : Q3) (Q1=Low, HQ3=the Highest.)
・If the Quality is set-up to HQ1, HQ2, or HQ3, the Web Browser doesn’t refresh the
live screen, and the Client Software is not connectable.
・When the Quality is set-up to HQ3, you can select ON/OFF of "Simultaneous
Recording/Playback". If try to reproduce on the invalid mode, "Simultaneous
Recording/Playback is not available. Please confirm the recording setting." will be
displayed. (When you set-up the Alarm / Motion recording mode, this unit can not
execute playback because it is on the recording stand-by mode.)
If you set-up at HQ3, and check "Simultaneous Recording/ Playback", Field Rate is
reduced. （NTSC：30F/S、PAL：24F/S）