Sony STR-DN1010 - Manual (Page 107)

107 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB05ENJ_STR-DN1010-CEL.fm masterpage: Right
STR-DN1010
4-174-068-12(1)
Ad
v
a
nced Operations
For details on the Auto Calibration, see
“Calibrating the appropriate speaker settings
automatically (Auto Calibration)” (page 38).
See “Before you perform Auto Calibration”
(page 38) before performing the Auto
Calibration.
To operate on the receiver
1 Press GUI MODE repeatedly to select
“MENU OFF”.
2 Press AMP.
Receiver operation is enabled.
3 Press MENU.
4 Press V/v repeatedly to select “<AUTO
CAL>” , then press or b.
5 Press V/v repeatedly to select “A.CAL
START”, then press to start the
measurement.
Measurement starts in 5 seconds. A count
down is displayed.
Note
While the time is counting down, stand away
from the measurement area to avoid
measurement error.
6 Measurement starts.
The measurement process will take
approximately 30 seconds. Wait until the
measurement process completes.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
– Press ?/1.
– Press the input buttons on the remote or
press the INPUT SELECTOR +/–
repeatedly on the receiver.
– Press MUTING (RM-AAP051 only) or
(RM-AAP052 only) on the remote. You can
also use MUTING on the receiver.
– Press SPEAKERS on the receiver.
– Change the volume level.
– Connect the headphones.
Tips
• Operations other than turning the receiver on or off
are deactivated during Auto Calibration.
• The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
To confirm/save Auto
Calibration results when GUI
function is turned off
1 Confirm the measurement result.
When the measurement ends, a beep
sounds and the measurement result appears
on the display.
a) xxx represent a speaker channel.
F Front
S Surround
SB Surround back
FH Front high
Depending on the error code, the speaker
channel may not appears.
b) xx represent an error code.
Performing Auto Calibration
Measurement process
[Display] Explanation
Completes properly
[SAVE EXIT] Proceed to step 2.
Fails
[E -
xxx a)
: xx b)
]
See “Message list
after Auto
Calibration
measurement”
(page 43).
continued