Sony STR-DN1010 - Manual (Page 112)

112 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB06REM_STR-DN1010-CEL.fm masterpage: Left
STR-DN1010
4-174-068-12(1)
Programming the remote
You can customize the remote to match the
components connected to your receiver. You
can even program the remote to control non-
Sony components and also Sony components
that the remote is normally unable to control.
Before you begin, note that:
– You cannot change the settings of DMPORT
input buttons.
– The remote can control only components
that accept infrared wireless control signals.
Be sure to turn on the receiver and
point the remote towards the
receiver when performing the
following procedure.
1
Press and hold RM SET UP,
then press AV ?/1.
The RM SET UP indicator flashes slowly.
2
Press the input button for the
component you want to control.
For example, if you are going to control a
VCR connected to VIDEO 1 IN, press
VIDEO 1.
The RM SET UP and SHIFT indicator
light up.
3
Press numeric buttons to enter
the numeric code (or one of the
codes if more than one code
exists) corresponding to the
component and the maker of
the component you want to
control (including TV button).
See the tables on page 113–116 for
information on the numeric code(s).
Note
For a TV remote code value, only numbers in
the 500’s are valid.
4
Press ENTER.
Once the numeric code has been verified,
the RM SET UP indicator slowly flashes
twice and the remote automatically exits
the programming mode.
5
Repeat steps 1 to 4 to control
other components.
Notes
• The indicator turns off while a valid button is
pressed.
• In step 2, if you press TUNER, you can only
program the button to control a tuner (page 113).
• For the numeric codes, only the last three numbers
entered are valid.
To cancel programming
Press RM SET UP during any step. The RM
SET UP indicator flashes 5 times in quick
succession. The remote automatically exits the
programming mode.
To activate the input after
programming
Press the programmed button to activate the
input you want.
Using the Remote
RM
SET UP
TV
SHIFT
Input
buttons
AV ?/1
Numeric
buttons
ENTER