Sony STR-DN1010 - Manual (Page 79)

79 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB05ENJ_STR-DN1010-CEL.fm masterpage: Right
STR-DN1010
4-174-068-12(1)
S-A
IR Oper
ations
To perform pairing
1
Place the S-AIR sub unit that
you want to pair near the S-AIR
main unit.
2
Match the IDs of the S-AIR main
unit and the S-AIR sub unit.
• To set the ID of the S-AIR main unit,
see “To set the ID of the S-AIR main
unit” (page 77).
• To set the ID of the S-AIR sub unit,
refer to the operating instructions
supplied with the S-AIR sub unit.
3
Press GUI MODE.
After “MENU ON” appears on the
display for a while, “GUI” appears and
the GUI menu appears on the TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
4
Press V/v repeatedly to select
“Settings”, then press or b.
The Settings menu list appears on the TV
screen.
5
Press V/v repeatedly to select
“S-AIR”, then press or b.
Note
When the S-AIR transmitter (not supplied) is
not inserted into the S-AIR main unit, “S-AIR”
cannot be selected.
6
Press V/v repeatedly to select
“Pairing”, then press or b.
“Put the S-AIR sub unit near the S-AIR
main unit. Turn on power and start
pairing.” appears on the TV screen. The
S-AIR main unit is ready to start pairing.
7
Press B/b repeatedly to select
“Yes”, then press .
The S-AIR main unit starts pairing.
“Pairing. Do the pairing operation with
the S-AIR sub unit.” appears.
8
Start pairing of the S-AIR sub
unit.
Refer to the operating instructions of the
S-AIR sub unit.
Notes
• Perform pairing within 5 minutes in step 7. If
you do not, pairing is recognized as failed,
and the screen changes accordingly. In this
case, see “If pairing fails” (page 79).
• When sound transmission is established,
“Pairing complete. To do the pairing another
one, select “Continue”.” appears.
9
Press B/b repeatedly to select
“Finish” or “Continue”, then
press .
• “Finish”: Finishes pairing.
• “Continue”: Continues to perform
pairing to another S-AIR sub unit.
Tip
You can confirm the pairing completion or the
current ID by checking the “S-AIR Settings”
screen. “Pairing” appears beside the current
S-AIR ID.
10
Press GUI MODE.
The GUI menu turns off.
Note
After you have performed pairing, if you select
the “S-AIR ID” menu, the ID setting (“A”, “B”
or “C”) that you last used is displayed.
If pairing fails
“Pairing failed. Retry?” appears.
To perform pairing again, select “Yes”.
To finish pairing, select “No”.
To quit pairing during setting
Press RETURN/EXIT O.
To cancel pairing
Perform the ID setting of the main unit
according to the procedure of “To set the ID of
the S-AIR main unit” (page 77). If you reset
the ID (even the same ID again), pairing is
canceled.