Sony STR-DN1010 - Manual (Page 88)

88 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB05ENJ_STR-DN1010-CEL.fm masterpage: Left
STR-DN1010
4-174-068-12(1)
Using a bi-amplifier
connection
1
Press GUI MODE.
After “MENU ON” appears on the
display for a while, “GUI” appears and
the GUI menu appears on the TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
2
Press V/v repeatedly to select
“Settings” then press or b.
The Settings menu list appears on the TV
screen.
3
Press V/v repeatedly to select
“Speaker”, then press or b.
4
Press V/v repeatedly to select
“SP Pattern”, then press or
b.
5
Press V/v repeatedly to select
the appropriate speaker pattern
so that there are no surround
back speakers and front high
speakers, then press
.
6
Press V/v repeatedly to select
“SB Assign”, then press or
b.
7
Press V/v repeatedly to select
“BI-AMP”, then press .
The same signals output from the
SPEAKERS FRONT A terminals can be
output from the SPEAKERS
SURROUND BACK/FRONT HIGH/
BI-AMP/FRONT B terminals.
To exit the menu
Press MENU.
Notes
• Set “SB Assign” to “BI-AMP” before you perform
Auto Calibration.
• If you set “SB Assign” to “BI-AMP”, the speaker
level and distance settings of the surround back
speakers and front high speakers become invalid,
and those of the front speakers are used.
• If you set “SP Pattern” to a setting with surround
back speakers or front high speakers, you cannot
set “SB Assign” to “BI-AMP”.