Setting up the auto calibration – Sony STR-DN1010 User Manual
Page 39
39
GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB04GET_STR-DN1010-CEL.fm
masterpage: Right
STR-DN1010
4-174-068-12(1)
Pre
p
ar
ing the
R
eceive
r
* Be sure to set the speaker pattern setting with front
1
Connect the supplied optimizer
microphone to the AUTO CAL
MIC jack.
2
Set up the optimizer
microphone.
Place the optimizer microphone at your
listening position. Use a stool or tripod so
that the optimizer microphone remains at
the same height as your ears.
On setting up the active
subwoofer
• When a subwoofer is connected, turn on the
subwoofer and turn up the volume
beforehand. Turn the MASTER VOLUME
to just before the mid-point.
• If you connect a subwoofer with a crossover
frequency function, set the value to
maximum.
• If you connect a subwoofer with an auto
standby function, set it to off (deactivated).
Note
Depending on the characteristics of the subwoofer
you are using, the setup distance value may be
further away from the actual position.
1: Setting up the Auto
Calibration
Optimizer
microphone
When using front high
speakers
*
When using surround back
speakers