Sony STR-DN1010 - Manual (Page 108)

108 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB05ENJ_STR-DN1010-CEL.fm masterpage: Left
STR-DN1010
4-174-068-12(1)
2 View the measurement result.
Press AMP and then press
V/v repeatedly
to select the item. Then press .
3 Save the measurement result.
Select “SAVE EXIT” in step 2.
“COMPLETE” appears on the display and
the settings are registered as selected
position number.
4 Select the calibration type.
Press
V/v repeatedly to select CAL TYPE,
then press .
5 Disconnect the optimizer microphone
after you have finished.
Note
If you have reposition your speaker, we recommend
that you perform Auto Calibration again to enjoy the
surround sound.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low frequency characteristics.
The measurement results may vary, depending on
the position of the optimizer microphone and
speakers, and the shape of the room. It is
recommended that you follow the measurement
results. However, you can change those settings in
the Speaker Settings menu. Save the measurement
results first, then try to change the settings if you
want.
When you select “PHASE
INFO.”
You can check the phase of each speaker
(in phase/out of phase).
1 Press V/v repeatedly to select a
speaker you want to check.
* xxx represent a speaker channel.
FL Front left
FR Front right
CNT Center
SL Surround left
SR Surround right
SBL Surround back left
SBR Surround back right
LH Front left high
RH Front right high
SW Subwoofer
Depending on the measurement result, the
speaker channel may not appears.
Item and explanation
EXIT
Exits the setting process without saving the
measurement results.
LEVEL INFO.
Displays the measurement result for speaker
level.
DIST. INFO.
Displays the measurement result for speaker
distance.
PHASE INFO.
Displays the phase of each speaker (in phase/out
of phase). See “When you select “PHASE
INFO.”” (page 108).
WARN CHECK
Displays warning concerning the measurement
results. See “Message list after Auto Calibration
measurement” (page 43).
SAVE EXIT
Saves the measurement results and exits the
setting process.
RETRY
Performs the Auto Calibration again.
Calibration type and explanation
FULL FLAT
Makes the measurement of frequency from each
speaker flat.
ENGINEER
Sets the frequency characteristics to a set that
matches that of the Sony listening room
standard.
FRONT REF
Adjusts the characteristics of all the speakers to
match the characteristics of the front speaker.
OFF
Set the Auto Calibration to off.
Display and explanation
xxx * : IN
The speaker is in phase.
xxx * : OUT
The speaker is out of phase. The “+” and “–”
terminals of the speaker may be connected the
other way around. However, depending on the
speakers, “xxx:OUT” appears on the display
even though the speakers are connected
properly. This is because of the speakers’
specifications. In this case, you can continue to
use the receiver.