Sony STR-DN1010 - Manual (Page 99)

99 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB05ENJ_STR-DN1010-CEL.fm masterpage: Right
STR-DN1010
4-174-068-12(1)
Ad
v
a
nced Operations
Notes
• This parameter is not available when “Ctrl for
HDMI” is set to “OFF”.
• When “AUTO” is selected, it may take a little more
time for the image and sound to be output to the TV
than when “ON” is selected.
• When the receiver is in standby mode,
“A.STANDBY” appears on the display if “Pass
Through” is set to “AUTO” or “ON”. However,
“A.STANDBY” will disappear when “Pass
Through” is set to “AUTO” and no signals are
detected.
Lets you set the audio output for HDMI from
the playback component connected to the
receiver via an HDMI connection.
x AMP
The HDMI audio signals from the playback
component is only output to the speakers
connected to the receiver. Multi channel sound
can be played back as it is.
Note
Audio signals are not output from the TV speakers
when “Audio Out” is set to “AMP”.
x TV+AMP
The sound is output from TV’s speaker and the
speakers connected to the receiver.
Notes
• The sound quality of the playback component
depends on the TV’s sound quality, such as the
number of channels, and the sampling frequency,
etc. When the TV has stereo speakers, the sound
output from the receiver is also stereo as that of the
TV, even if you play back multi channel source.
• When you connect the receiver to an image display
component (projector, etc.), sound may not be
output from the receiver. In this case, select
“AMP”.
• When you select the input that you have assigned
the HDMI input, sound does not output from the
TV.
Lets you set the level of the subwoofer to 0 dB
or +10 dB when PCM signals are input via an
HDMI connection. You can set the level for
each HDMI input independently.
x AUTO
Automatically sets the level to 0 dB or +10 dB
depending on the frequency.
x +10 dB
x 0 dB
Lets you set the low pass filter of the
subwoofer when multi channel Linear PCM
signals are input via an HDMI connection.
Set the “SW L.P.F.” if your connected
subwoofer’s crossover frequency do not have
low pass filter.
x ON
The low pass filter of the subwoofer’s cut off
frequency is set to 120 Hz.
x OFF
The low pass filter of the subwoofer is turned
off.
Audio Out (Setting HDMI audio
input)
SW Level (Subwoofer level for
HDMI)
SW L.P.F. (Subwoofer Low Pass
Filter for HDMI)