Sony STR-DN1010 - Manual (Page 111)

111 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB05ENJ_STR-DN1010-CEL.fm masterpage: Right
STR-DN1010
4-174-068-12(1)
Ad
v
a
nced Operations
1
Select a channel you want to
preset.
For details on this operation, see
“Selecting channels from a category
(CATEGORY TUNING)” (page 110).
2
Press SHIFT, then press
MEMORY.
“MEM” lights up on the display.
3
Press PRESET + or PRESET –
to select a preset number.
You can also select the number by
pressing SHIFT, then numeric buttons.
Preset numbers from 1 to 30 are available.
Channel 1 is preset for the preset numbers
when you purchase the receiver.
4
Press MEMORY.
If SHIFT indicator is light off before you
press MEMORY, press SHIFT.
“MEM” lights off.
5
Repeat steps 1 to 4 to preset
another channel.
Selecting a preset channel
1 Press TUNER repeatedly to select
“SIRIUS”.
2 Press PRESET + or PRESET –
repeatedly to select the preset channel
you want.
You can also press SHIFT, then numeric
buttons to select the preset channel you
want. Then, press
to enter the selection.
You can change the brightness of the front
panel display.
1
Press AMP.
2
Press MENU.
3
Press V/v repeatedly to select
“SYSTEM”, then press or b.
4
Press V/v repeatedly to select
“DIMMER”, then press or b.
5
Press V/v repeatedly to select
the setting you want, then
press .
The front panel display will change the
brightness according to the setting you
have selected.
Tip
You can also use DIMMER on the receiver to
change the brightness of the front panel display.
Presetting satellite tuner
channels (Models of area code
U2, CA2 only) Changing the brightness of the
front panel display (DIMMER)