Philips SFF 6135D - Manual (Page 73)

Service · Cleaning 73
EN
Cleaning
Introduction
If lines appear on the printed pages or on the fax trans-
missions or documents are not properly fed, you should
clean the scanner.
Switching Off the Device
Switch the device off and disconnect from the power
supply before you clean it.
Switching Off the Device
Gerät ausschalten
Recommissioning
Instructions for Cleaning!
Cleaning the Scanner
1 Open the scanner cover.
2 Carefully wipe the scanner glass of the flatbed scan-
ner with a lint-free cloth.
3 Close the scanner cover.
Calibrating the Scanner
Calibrating the Scanner
If vertical lines appear on the printed pages or on the fax
messages, it is possible the scanner needs to be cali-
brated.
Instructions for Calibrating!
1 Insert a white piece of paper onto the flatbed scanner.
CAUTION!
Switching off the device!
Turn the device off using the on/off switch on
the back before you remove the plug from the
socket.
CAUTION!
Recommissioning!
Plug the power cable into the electrical outlet.
Only after switch the device on using the on/
off switch on the rear.
DANGER!
Instructions for Cleaning!
Use a soft, lint-free cloth. Never use liquid or
easily flammable cleansers (sprays, abrasives,
polishes, alcohol, etc.). Do not allow any
moisture to reach the interior of the device.
Moisten the cloth slightly with cleaning alco-
hol in order to remove stubborn marks. The
cloth must however, never be wet.
CAUTION!
Instructions for Calibrating!
The scanner is calibrated in the factory and
normally no new calibration is needed. Do not
use this function frequently. Clean the the
scanner glass and the scanner film first before
calibrating the scanner (see also chapter
Cleaning, page 73).