Nortel Networks NN10265-111 - Manual (Page 78)

NN10265-111 MCS 5100 3.5 Standard 4.0 January 2006
78 Copyright © Nortel Networks Limited 2006
10 To create the sixth partition type n and press Enter. Press Enter
to accept the default beginning block, then type +10000M and
press Enter for the size.
Command (m for help):n
First cylinder (17005-35242, default 17005): <Enter>
Using default value 17005
Last cylinder or +size or +sizeM or +sizeK
(17005-35242, default 35242): +10000M
11 To create the seventh partition type n and press Enter. Press
Enter to accept the default beginning block, then press Enter
again to accept the default value for the last block.
Command (m for help):n
First cylinder (27006-35242, default 27006): <Enter>
Using default value 27006
Last cylinder or +size or +sizeM or +sizeK
(27006-35242, default 35242): <Enter>
12 Type p and press Enter to view the final partition table. Example
output:
Disk /tmp/sda: 64 heads, 32 sectors, 35242 cylinders
Units= cylinders of 2048 * 512 bytes
Device Boot Start End Blocks Id System
/tmp/sda1 1 1001 1025008 83 Linux
/tmp/sda2 1002 6002 5121024 83 Linux
/tmp/sda3 6003 7003 1025024 82 Linux swap
/tmp/sda4 7004 35242 28916736 5 Extended
/tmp/sda5 7004 17004 10241008 83 Linux
/tmp/sda6 17005 27005 10241008 83 Linux
/tmp/sda7 27006 35242 8434672 83 Linux
13 Press w and press Enter to save changes.
14 Press q and press Enter to exit.
Initiate restore
The following provides instructions to initiate the restore.
From the terminal server
1 Format the partitions.
mke2fs /dev/sda1 <Enter>
mke2fs /dev/sda2 <Enter>
mkswap /dev/sda3 <Enter>
mke2fs /dev/sda5 <Enter>
mke2fs /dev/sda6 <Enter>
mke2fs /dev/sda7 <Enter>