Nortel Networks NN10265-111 User Manual
Page 92
NN10265-111 MCS 5100 3.5 Standard 4.0 January 2006
92
Copyright © Nortel Networks Limited 2006
9
Set the HA Config value to Enabled. Also, set the Domain that
is being configured to Enable, and Disable for the other domain.
CPU in slot 7 is Domain A, and CPU in slot 9 is Domain B.
Example for Domain A, the Host Card in slot 7:
HA Config [Enabled]
Domain A [Enabled]
Domain B [Disabled]
10
Press Esc twice to return to the Advanced menu.
11
Move to Remote Console and press Enter.
12
Verify, or change, the values on screen to match the values listed
below. Leave all other values as default.
COM Port: [COM B]
Serial port B: [Enabled]
Base I/O address: [2F8]
Interrupt: [IRQ 3]
Baud Rate: [9600]
Console Type: [VT100]
Flow Control: [None]
Screen Lines: [25]
Active After Post: [On]
13
Press Esc twice to return to the Advanced menu.
14
From the Boot menu, move the cursor to Boot Device Priority
and press Enter.
15
Ensure the system boots in the following order:
8XX SCSI CD-ROM LSI Logic
+Hard Drive
! +Removable Devices
! ATAPI CD-ROM Drive
! Legacy Network Boot
Place an exclamation mark (!) beside the appropriate devices to
disable them.
16
Press the Esc key to return to the main menu.
17
Move to the Security menu to set control access to the BIOS
settings. Unauthorized BIOS access enables any Linux security
to be circumvented.
18
Set up the BIOS supervisor password. Ensure the password on
Boot option is disabled.
19
Move to the Exit menu to save changes and exit the BIOS set
up. The system will reboot.