Appendix b: rtp media portal installation, How this chapter is organized, Prerequisites – Nortel Networks NN10265-111 User Manual
Page 85
MCS 5100 RTP Media Portal Basics
Copyright © Nortel Networks Limited 2006
Appendix B: RTP Media Portal
installation
How this chapter is organized
This chapter is organized as follows:
•
•
•
Installing RTP Media Portal on page 90
•
Installing MCPN765 cards on page 104
Prerequisites
This chapter provides instruction for installing a new RTP Media Portal.
It is assumed that hardware is already assembled as follows:
•
MCPN765 I/O blades are installed in front slots 1-6 for Domain A,
and slots 11-16 for Domain B.
•
PIMC-0101 765 transition modules are installed in rear slots 1-6 for
Domain A, and slots 11-16 for Domain B.
•
CPV5370 host blades are installed in front slot 7 for Domain A, and
slot 9 for Domain B.
•
5370 transition modules are installed in rear slot 7 for Domain A,
and slot 9 for Domain B.
•
CPX8216T HSC/BR hot swap controllers are installed in front slot 8
for Domain B, and slot 10 for Domain A.
•
Hard drives and CD-ROM drives are installed in the front peripheral
bay.
•
Floppy drives are installed in rear peripheral bay.
Installing the RTP Media Portal software consists of placing the
required packages on the hard drive of the host blade. As the host blade
is the only blade in the system that has a hard drive, it is also configured