NCR S16 - Manual (Page 106)

Configuration Settings Required for Installing MP-RAS
11-16 Installing MP-RAS
Embedded Adaptec AIC-7880 SCSI Controller
•
On Board SCSI AIC-7880 – Enabled
•
Boot device – Enabled
•
Configure the on board SCSI to IRQ 11
Disk Array Adapter Mylex RAID Controller
•
Disable the on board SCSI boot device in BIOS Setup. This is the “Boot
Device” found under “On Board SCSI AIC-7880” in the BIOS Setup.
•
Do not disable the “On Board SCSI AIC-7880” if the intended boot drive
is not connected to the RAID controller.
•
Configure IRQ 14 (INTA 14) to RAID controller.