NCR S16 - Manual (Page 73)

SCO Release 3: Installing TCP/IP Communications
NCR S16 Minitower Server Installing Network Operating System 8-7
SCO Release 3: Installing TCP/IP
Communications
Always defer Network Installation, because there may not be a driver listed
within the SCO UNIX Installation for the NIC configured in the unit.
Use the latest SCO UNIX drivers for your SCSI controller and NIC.
To install TCP/IP, follow these steps:
1. Enter Maintenance Mode (Press Enter on boot; init 1 or shutdown -i).
2. Begin an Install (/etc/custom, install or sysadmsh, System, Software,
Install).
3. Select A NEW PRODUCT.
4. Select PACKAGES.
Inserting the Latest SMC Driver Disk
To insert the latest SMC driver disk, follow these steps:
1. Insert the latest SMC driver disk and press CONTINUE.
2. The “Select packages from which to choose files and press <Return>“
message displays. Select the following:
SMC 8432, 8434 and 9332 Ethernet driver v1.0.2a
3. When the “Insert the requested volume and press <Return> to continue the
installation” message displays, press Enter. Verify that the SMC driver is
installed correctly, then exit.
4. At the # prompt, type “netconfig.”
5. Select “1. Add a chain.” “Sco_tcp->lo0” is a “loopback” test and cannot
be used for active IP connections. For the SMC, an entry similar to the
following is listed if installed:
“sco_tcp->smpw0
smpw0 smpw SMC8432, 8434 and 9332 Ethernet Adapter, board
0”