NCR S16 - Manual (Page 62)

Installing NetWare
7-8 Installing Netware
Installing NetWare
During the installation processes, you are asked many hardware-specific
questions. Most of these can be answered by choosing the default (highlighted)
option, but in some cases specific information is required.
Note: Know your hardware before attempting this installation. You should
install all drivers for your network interface boards on the hard drive where
they can be accessed easily. For example, for SMC adapters, you should
install the files in the directory, c:\smc.
To install NetWare, follow these steps:
1. At the CD-ROM drive letter prompt (D:, for example), type INSTALL.
2. When prompted to “Select the type of installation desired,” select
NetWare Server Installation and press Enter.
3. When prompted to “Choose the product you want to install,” select
NetWare 4.1 and press Enter.
4. When prompted to “Select the type of installation you are performing,”
select Simple Installation of NetWare 4.1 and press Enter.
5. When prompted to “Specify the server name,” enter a short descriptive
alphanumeric title and press Enter.
6. Assign an internal IPX number. To select the default, press Enter.
7. Select the source and destination paths. To select the defaults, press
Enter.
8. Select a local configuration and press Enter.
9. Select a filename format. Press Enter to select DOS.
10. To specify special startup commands, select Yes and press Enter.
Otherwise, select No.
11. To allow NetWare to run from AUTOEXEC.BAT, select Yes and press
Enter. Otherwise, select No.