NCR S16 - Manual (Page 89)

Rebooting the Server and Installing the Operating System
NCR S16 Minitower Server Installing Network Operating System 10-5
8. When the Advanced Options screen displays, select OK.
9. When the Complete screen displays, select OK.
Editing CONFIG.SYS and Rebooting
To edit CONFIG.SYS and reboot, follow these steps:
1. After completing the installation, you must edit the CONFIG.SYS file on
your bootable fixed disk drive and again add the following line(s) (as
appropriate) to the file:
BASEDEV=AIC7870.ADD
BASEDEV=DAC960.ADD
2. If using the Mylex controller you must remark out the following line:
BASEDEV=IBMINT13.I13
3. Verify that the install copied the files from your boot flex diskette to the
fixed disk. If the file(s) were not copied, you must copy the files
manually. Without the addition of the line(s), your CD-ROM will cease
to function.
4. Reboot and watch the screen for any errors. If errors display, write them
down if possible.
The installation of OS/2 is complete.