Choosing drivers, Switching to the system console screen – NCR S16 User Manual

Page 63

Advertising
background image

Installing NetWare

NCR S16 Minitower Server Installing Network Operating System

7-9

Choosing Drivers

This process looks for SCSI controller drivers to enable use of the hard disk(s)
and other storage devices attached to that SCSI channel.

1. When prompted to “Choose the Server Drivers - Disk Driver,” select

AIC7870.DSK and press Enter. The listings are always in alphabetical
order so you may have to scroll up or down using the arrow keys.

2. When prompted, “Do you want to select an additional Disk driver?” select

No and press Enter. The “Scanning for available drivers....” message
displays. This process looks for the network interface board (.LAN)
drivers.

3. When prompted to “Choose the Server Drivers - Network Drivers,” press

F10 to continue without selecting.

4. When the “Choose the Server Drivers - Summary” screen displays,

choose Select/Modify driver parameters and press Enter. You must enter
your Slot # [the bus slot where the EISA /PCI controller board is located,
in the case of the S16, the embedded SCSI controller is listed as slot #32],
press to Save the parameters and continue, and press Enter.

5. At the Driver Actions menu, select Continue installation.

6. Press Enter to select “slot=32” and continue installing the drivers.

7. When prompted that no LAN driver has been installed, press Enter.

8. When the “Choose the Server Drivers - Summary” and “Driver Actions”

screens display, select Continue installation and press Enter.

Switching to the System Console Screen

To switch to the System Console Screen, follow these steps:

1. When the “Control will be switched to the system console screen...”

message displays, press Enter. The console prompt {:} then displays.

2. Your .LAN driver loads and prompts you to verify the slot number. If

correctly listed, press Enter to load the driver.

Advertising