NCR S16 - Manual (Page 65)

Installing NetWare
NCR S16 Minitower Server Installing Network Operating System 7-11
4. If your topology requires a different type or additional type support (such
as Ethernet_802.3, Ethernet_II or Ethernet_SNAP, etc.), change the line
which loads your SMCPWR .LAN driver to read:
LOAD SMCPWR SLOT=? FRAME=???? NAME=SMCPWR_1_E83
Or, add additional LOAD statements to load more frame types. If
attaching this server to existing wiring, you must also edit the NET= entry
on the BIND statement to mirror the existing network segment number.
Sample AUTOEXEC.NCF File
A typical AUTOEXEC.NCF file might appear as follows:
set Time Zone = EST5EDT
set Daylight Savings Time Offset = 1:00:00
set Start Of Daylight Savings Time = (APRIL SUNDAY
FIRST 2:00:00 AM)
set End Of Daylight Savings Time = (OCTOBER SUNDAY
LAST 2:00:00 AM)
set Default Time Server Type = SINGLE
set Bindery Context = O=ATT
file server name ATT_41
ipx internal net 2F24147B
LOAD SMCPWR SLOT=16 AUTODETECT LINE_SPEED=10
FRAME=ethernet_802.3 NAME=SMCPWR_1_E83
BIND IPX SMCPWR_1_E83 NET=ABCDDCBA
mount all
5. Press F10 to save any changes.
6. At the Installation Options screen, highlight NCF files options and press
Enter. Highlight Edit STARTUP.NCF and press Enter. Familiarize
yourself with the contents of the file in the event of catastrophic failure
and/or corruption of the file.
7. Press Esc three times to exit.
8. At the : prompt, type DOWN and press Enter to end the server processes
and dismount all drives. Verify no users are logged in before bringing the
server down.
9. At the : prompt, type EXIT and press Enter to exit to the DOS prompt.
10. Reboot the server and watch the boot up process for any errors.
Note: If you did not add the SERVER.EXE load to your
AUTOEXEC.BAT file, you must manually add a line to this file. In a