NCR S16 - Manual (Page 18)

Configuring PCI Adapters
2-6 Confirming the CMOS Settings and Configuring PCI Adapters
Configuring PCI Adapters
To configure PCI adapters, follow these steps:
1. Select PCI System Configuration from the main menu in BIOS Setup.
Figure 2-1. PCI System Configuration Screen
PCI System Configuration
PCI IRQ Setting
PCI Slot 1
PCI Slot 2
PCI Slot 3
PCI Slot 4
Onboard SCSI
VGA Palette Snoop
Onboard SCSI
Boot Device
[ Manual ]
[ Disabled ]
[ Enabled ]
[ Enabled ]
. . . . . . . . . . .
. . . . . . . . . . .
. . . . . . . . . . .
. . . . . . . . . . .
. . . . . . . . . . .
. . . . . . . .
. . . . . . . .
. . . . . . . . . . . .
. . . . . . . . .
INTA
[--]
[--]
[--]
[--]
[--]
INTB
[--]
[--]
[--]
[--]
INTC
[--]
[--]
[--]
[--]
INTD
[--]
[--]
[--]
[--]
= Move Highlight Bar,
PgDn/PgUp = Move Screen, F1 = Help, Esc = Exit
= Change setting,
Page 1/1
2. Press and to select the PCI slot number. Press and to change
the IRQ Level for INTA Pin settings.
– Available IRQ settings are 3, 4 ,5, 7, 9, 10, 11, 14*, and 15.
– To make IRQ 3 available for selection, you must disable Serial Port 2
in the System Security menu.
– To make IRQ 4 available for selection, you must disable Serial Port 1
in the System Security menu.
– To make IRQ 7 available for selection, you must disable Parallel Port
1 in the System Security menu.
See Appendix C in your system User Guide for settings for sample
configurations.