NCR S16 - Manual (Page 39)

Pre-Loaded Installation
NCR S16 Minitower Server Installing Network Operating System 5-3
Pre-Loaded Installation
If your system was pre-loaded at the factory with Microsoft Windows NT
Server, you need to complete the installation of the system by providing
several site-specific configuration items.
This section describes the procedure to complete the pre-loaded installation of
Microsoft Windows NT on your server.
Starting the Pre-Loaded Installation
To start the pre-loaded installation, follow these steps:
1. Carefully read the warning on the previous page.
2. Verify that both the mouse and the keyboard are plugged into the
appropriate receptacles in the back of the system.
3. Verify your system is connected to the network onto which it will be
installed. Before continuing, verify you have the following information:
– The name of your domain
– The unique name of this system
– Whether this system will be the Primary Domain Controller (PDC) or
a Backup Domain Controller (BDC)
4. Remove the yellow CAUTION label from the front of the system, and
open the disk drive access door.
5. Power on the system by pressing the power button on the front panel or
inside the disk drive access door. The system begins its POST tests and
prepares for completion of the Windows NT installation.
Entering the Setup Routine for NCR Server Manager
To enter the setup routine for NCR Server Manager, follow these steps:
1. After the POST tests have completed, and several Windows NT screens
have briefly displayed, enter the setup routine for NCR Server Manager.